F3D Filament PVA 500 gram soluble
|Enter your email|
|Shipping within||24 hours|
|The Availability Of||0 awry.|
|The bar code|
PVA – Polyvinyl Alcohol is a water-soluble, low-temperature support material. The filament is used to print complex models in which it is difficult or even impossible to remove support. Thanks to its properties, printing is a pleasure, it is enough to immerse in warm water, and after a few minutes (depending on the number and thickness of the supports) we take out a clean print. The material does not require a mulled table. Special features:
- low shrinkage of the material,
- easy printing
- print temperature from 180°C,
- no heated table required,
- 1.75 mm and 2.85 mm (± 0.03 mm).
- diameter: 1.75 mm
There is currently no comments or ratings for this product.